Shop reference · PDF · 10 pages
Press Brake Reference: bend allowance, tonnage and minimum flange
The numbers a setup tech and an estimator both need, in one place. Every table states its method: bend allowance from the neutral axis, K-factor by radius ratio, tonnage per metre, minimum flange with the die check, and the hole-to-bend limits. No pass/fail, no filler.
CA$29 · one payment · download immediately and again for 30 days · no account
What is inside
- Bend allowance formula and the K-factor table by R/T (0.25 to 4)
- Bend deduction, worked, with the flat-length arithmetic
- Minimum inside radius by material and temper — 8 materials
- V-die selection, 0.5 mm to over 12 mm
- Minimum flange, with the die half-width check
- Air bend, bottoming and coining — what each does to radius, angle, tonnage and tool life
- Tonnage per metre formula, worked example, coining worked example, and rating rules
- Hole-to-bend, hole-to-edge, hole-to-hole limits
- Gauge to millimetre table, and why gauge is not a measurement
- Springback, and what tighter than ±1° actually costs
- Ten-step flat pattern checklist for the setup sheet
- Field notes: back the real K out of one test bend, short-flange relief, aluminium cracking, shimming a tapered angle, galling control, coin-into-a-pad, collision-free sequence
- Quoting traps — six drawing signs and what each really costs in setup
A worked line, exactly as printed
BA = (π / 180) × 90 × (3.0 + 0.40 × 3.0) = 1.5708 × 4.20 = 6.60 mm
BD = 2 × (3.0 + 3.0) × tan 45° − 6.60 = 12.00 − 6.60 = 5.40 mm
Two 40 mm flanges: 40 + 40 − 5.40 = 74.60 mm flat
The same page prints the tonnage rule so the die you picked does not overload the press: P = 1.42 · S · T² / V, with the 80 % rating rule and the material factors.
Why it exists
The internet repeats K = 0.33 as if it were universal — that is only the R/T ≈ 0.5 case, and using it on a wide-radius bend overshoots the allowance by a third. Meanwhile the useful tables sit scattered across press-brake brochures and forum posts. This is the corrected version, in one printable file, with the arithmetic shown so you can check every line.
What it does not cover
Bend sequence and collision, backgauge clearance, tooling wear, crowning and bed deflection, weld distortion, coating touch-up, and tolerance stack-up through an assembly. Each needs its own check, and the last three are why the preflight service exists.
Already send parts out for DFM checks?
Put the actual STEP file through the preflight and the geometry that breaks these limits is measured against them — $95 a part, or a free run first.
Run a free partFree calculators: bend allowance, tonnage, minimum flange, hole to bend and four more
Revision 1.0 · FABFLOW Preflight · fabflowpro.com · values are nominal air-bend figures in mild steel; press rating, die condition, material certificate and grain direction move the real number.