Reference · free · no account
Sheet metal formulas, with the rule each one enforces
Eight calculators. Every one prints the K it used and the assumption behind the number, and every one tells you what it costs to ignore — because a number without its limit is a number that gets a part scrapped.
The K-factor here is keyed to radius ratio, 0.28 at R/T 0.25 through 0.50 at R/T 4. The flat 0.33 quoted across the internet is only the R/T ≈ 0.5 case; on a wide-radius bend it shortens the allowance by about a third.
Bend allowance
Arc length of the neutral axis, K from R/T
Bend deduction
What you subtract from the flange sum
Flat length
Two flanges minus the deduction
Tonnage
Force per metre and the press it needs
Minimum flange
4T + R, with the die half-width check
Minimum radius
By material and temper
Hole to bend
2T + R and 1.5T to the edge
V-die selection
The opening range thickness allows
Also worth reading: how these compare to the calculators already out there, named and without flattery.
Why these are different
- K is keyed to R/T, interpolated between seven points — not fixed at 0.33.
- Assumptions print on the page. No result is presented as a verdict on the part.
- Each tool names its own failure mode. Tonnage warns about off-centre loading and punch tip load; radius warns about temper.
- Die and method factors are separate. Air, bottoming and coining multiply, because they do.
The whole set on paper
Every formula above, the full K table, minimum radius for eight materials, gauge conversion and ten field notes are in the CA$29 Press Brake Reference. The calculators here are free and always will be.
A calculator still needs the geometry typed in.
Drop the STEP file on the preflight and every bend, flange and hole is measured against these limits automatically — $95 a part, first part free.
Run a free part