Formulas · comparison
The bend calculators that already exist, compared
There is no shortage of free bend calculators. It is worth saying plainly what they do well, because a reference is only useful if it is honest about the field it sits in — and because the differences are exactly where parts get scrapped.
| Tool | Covers | Does well | Where it bites |
|---|---|---|---|
| CustomPartNet | Bend allowance, bend deduction | Typed into the flat pattern maths, imperial, calm and correct once you supply K | K is an input you must already know; no K table, no radius or tonnage limits |
| MachineMFG | Rules of thumb per thickness band, tonnage charts | Broad coverage, die and press detail, written by people who have run a brake | Rules of thumb rather than a keyed calculation; radius guidance is coarse |
| JotTools | Bend allowance, tonnage calculators | Quick, clean, no signup | K fixed or hand-entered, no method factor, no failure-mode explanation |
| Xometry | Minimum radius reference by material | Table format that reads well | Tuned to their own process; radius only, no tonnage or flange |
| 247 Tailor Steel | Radius explainer with metric tables | Clear diagrams and metric figures | Sells their service; no interactive calculation |
| Die-maker charts | Tonnage per metre, V selection | The origin of the numbers everyone reprints | Paper or PDF, die-specific, no material or method factors in one place |
The one structural difference
Nearly every calculator online asks you for a K-factor, or fixes it at 0.33. K is the neutral axis position and it moves with radius ratio: 0.28 at R/T 0.25, 0.40 at R/T 1.0, 0.50 at R/T 4 and above. A fixed 0.33 on a wide-radius bend shortens the allowance by about a third, so the blank comes out long, the flange will not gauge, and nobody blames the calculator.
These tools key K to R/T, interpolate between seven measured points, and print the K they used. That is the whole difference, and it is not cosmetic.
What is still worth using elsewhere
- For a full flat pattern with setbacks and inside dimensions, CustomPartNet is solid — bring your own K.
- For die and press hardware detail, MachineMFG goes deeper than anyone on the machine side.
- For material radius tables tied to a supplier's process, Xometry and 247 are worth reading before you design.
What none of them do
None of them measures your part. Every one needs the geometry typed in, bend by bend, and none knows whether the flange will clear the die once the tonnage is applied. That is the gap the preflight fills: drop the STEP file and every bend, flange and hole is measured against these limits automatically.