Laser cutting DFM
Laser cutting DFM check on the STEP file
Kerf width, pierce points, and hole-to-bend distance decide whether a laser-cut blank bends clean or tears. The check measures all of it before the nest is built.
What gets measured
- Hole diameterHole at least 1·t in diameter; smaller and the pierce leaves a cone.
- Hole to bendHole centre at least 2·t + r from the bend line.
- Hole to edgeHole centre at least 1.5·t from an outside edge.
- SlotsSlot width at least 1·t, with radiused ends rather than square.
Every finding prints the measured value and the limit it broke, graded RISK, NONCONFORMANCE or NEEDS_CLARIFICATION. It never prints a bare pass or fail.
Questions
- What does the report actually contain?
- Every finding carries the measured value, the limit it broke, and a confidence grade. Risky features are ranked worst first. The tooling block names the die width, the tonnage, and any special tool the geometry forces — louvre, curl, offset, or a narrow die. No pass/fail verdict.
- How fast is it?
- Four hours on a single part during your business day, eight on an assembly. A retainer is four hours per part, forty parts a week.
- What does it cost?
- 95 Canadian dollars for one part, 199 for an assembly up to 25 bodies, 299 a week for the retainer. Card up front, no quote call.
- What file do you need?
- A STEP file of the part. Nothing installed, no plugin, no account.
- What does it not catch?
- Material grade or grain direction, tolerance stack-up, weld distortion, coatings, bend sequence, and print-versus-model mismatch. Those are stated as limits on every report rather than guessed at.
Send one part this week and it comes back free.
You see the report before you see an invoice. STEP file in, four hours, no call needed.
Upload a STEP fileWant the numbers on paper?
The Press Brake Reference prints bend allowance, K by radius ratio, tonnage per metre, minimum flange and ten field notes. CA$29, PDF.