Waterjet DFM
Waterjet DFM check where taper matters
Waterjet buys tolerance at the cut but not at the brake. Hole-to-bend and hole-to-edge still decide whether the part survives forming, and taper needs a lead-in.
What gets measured
- Hole to bendAt least 2·t + r from the bend line, taper included.
- Hole to edgeAt least 1.5·t, more for thick stock where taper widens.
- Pierce clearancePierce points off the finished edge, or the entry cone shows.
- Stacked cuttingHoles under 1·t drift when stacked; mark them for single-cut.
Every finding prints the measured value and the limit it broke, graded RISK, NONCONFORMANCE or NEEDS_CLARIFICATION. It never prints a bare pass or fail.
Questions
- What does the report actually contain?
- Every finding carries the measured value, the limit it broke, and a confidence grade. Risky features are ranked worst first. The tooling block names the die width, the tonnage, and any special tool the geometry forces — louvre, curl, offset, or a narrow die. No pass/fail verdict.
- How fast is it?
- Four hours on a single part during your business day, eight on an assembly. A retainer is four hours per part, forty parts a week.
- What does it cost?
- 95 Canadian dollars for one part, 199 for an assembly up to 25 bodies, 299 a week for the retainer. Card up front, no quote call.
- What file do you need?
- A STEP file of the part. Nothing installed, no plugin, no account.
- What does it not catch?
- Material grade or grain direction, tolerance stack-up, weld distortion, coatings, bend sequence, and print-versus-model mismatch. Those are stated as limits on every report rather than guessed at.
Send one part this week and it comes back free.
You see the report before you see an invoice. STEP file in, four hours, no call needed.
Upload a STEP fileWant the numbers on paper?
The Press Brake Reference prints bend allowance, K by radius ratio, tonnage per metre, minimum flange and ten field notes. CA$29, PDF.