Formulas · free calculator
Bend allowance calculator
The arc length of the neutral axis through a bend — what the flat pattern gains.
K from R/T 1.5 = 0.44
BA = (π/180) × 90 × (3 + 0.44 × 2)
BA = 6.09 mm
Air-bend figures in mild steel unless stated. Nominal thickness; measure the coil. Values are a starting point — press rating, die condition, material certificate and grain direction move the real number.
Have the actual STEP file measured against these limits — first part freeThe rule
BA = (π / 180) × A × (R + K × T). K rises with R/T: 0.28 at R/T 0.25, 0.40 at 1.0, 0.50 at 4 and above.
Bend allowance is the base number for every flat pattern. Get it from K keyed to R/T, not from a flat 0.33.
What breaks when this is ignored
- K = 0.33 applied at R/T 3 gives an allowance about a third short — the flat comes out long and the flange will not gauge.
- Bend allowance used in place of bend deduction. BA adds to neutral length, BD subtracts from the flange sum. They are not interchangeable.
- Allowance computed from the drawing's nominal thickness while the coil is 0.1 mm over.
Notes from the floor
- Radius below 1 × T means coining or bottoming, and the tonnage goes up 5–8×.
- Test the first part: press, die and material lot move this by 10–20 %. Measure the real K with one trial bend.
All eight formulas on paper
The Press Brake Reference prints every table with the arithmetic worked, plus ten field notes. CA$29, PDF.
See the reference