Formulas · free calculator
Flat length from two flanges
Outside flange lengths minus the bend deduction — the blank you cut.
BD = 3.91 mm
Flat = 40 + 40 − 3.91
Flat = 76.09 mm
Air-bend figures in mild steel unless stated. Nominal thickness; measure the coil. Values are a starting point — press rating, die condition, material certificate and grain direction move the real number.
Have the actual STEP file measured against these limits — first part freeThe rule
Flat = F1 + F2 − BD, with BD = 2 × (R + T) × tan(A / 2) − BA
The last step of every flat pattern. Do it in the right order and the part forms; do it in the wrong order and you cut short.
What breaks when this is ignored
- Deducting the allowance instead of the deduction.
- Adding the deduction to a sum of inside dimensions.
- Ignoring that both flanges must clear the die — a 6 mm flange on a 16 mm V will not form.
Notes from the floor
- Check each flange against 4 × T + R before cutting. A flange under that will not bridge the die.
All eight formulas on paper
The Press Brake Reference prints every table with the arithmetic worked, plus ten field notes. CA$29, PDF.
See the reference