Formulas · free calculator
Minimum flange calculator
The shortest flange the die shoulders will let you form.
4 × T + R = 10 mm
V/2 + R + T = 12 mm
Minimum flange = 12 mm (larger governs)
Flange 15 mm clears the 12 mm minimum.
Air-bend figures in mild steel unless stated. Nominal thickness; measure the coil. Values are a starting point — press rating, die condition, material certificate and grain direction move the real number.
Have the actual STEP file measured against these limits — first part freeThe rule
Minimum flange = 4 × T + R, with a die check of at least V / 2 + R + T. The larger figure governs.
A flange under the minimum drops into the die. The limit belongs in the quote, not in a rework ticket.
What breaks when this is ignored
- Flange dimensioned to the bend line instead of the outside.
- Relief slots left off, when 1 × T relief at the flange ends would drop the limit to 2 × T + R.
- Forming in an air bend what needs an offset or gooseneck punch.
Notes from the floor
- Under the limit: narrower die, relief slots, offset punch, or form in two hits with a relief.
All eight formulas on paper
The Press Brake Reference prints every table with the arithmetic worked, plus ten field notes. CA$29, PDF.
See the reference