Formulas · free calculator
Hole-to-bend and hole-to-edge calculator
Whether a hole is far enough from a bend to survive forming.
Hole to bend: need 6 mm (2T + R)
Hole to edge: need 3 mm (1.5T)
Both distances clear the limits.
Air-bend figures in mild steel unless stated. Nominal thickness; measure the coil. Values are a starting point — press rating, die condition, material certificate and grain direction move the real number.
Have the actual STEP file measured against these limits — first part freeThe rule
Hole centre to bend line ≥ 2 × T + R. Hole centre to outside edge ≥ 1.5 × T.
Holes inside the bend zone pull into the radius and go oval. The limit is geometry, not opinion.
What breaks when this is ignored
- A hole placed by eye against the bend line with no dimension.
- Punching before forming with no allowance for the distortion zone.
- A slot left square-ended where a radiused end would relieve it.
Notes from the floor
- Too close: punch after forming, or replace the hole with a slot running away from the bend.
All eight formulas on paper
The Press Brake Reference prints every table with the arithmetic worked, plus ten field notes. CA$29, PDF.
See the reference