Formulas · free calculator
V-die opening selection
The die opening range thickness allows, and the radius it will produce.
Allowed V range = 12 to 24 mm
Radius this die produces ≈ 2.56 mm
V 16 mm is in range.
Air-bend figures in mild steel unless stated. Nominal thickness; measure the coil. Values are a starting point — press rating, die condition, material certificate and grain direction move the real number.
Have the actual STEP file measured against these limits — first part freeThe rule
V between 6 T and 10 T for normal work; 8 T as the default. Air-bend inside radius ≈ 0.16 × V.
The die sets the radius of an air bend and the tonnage that comes with it. Picking V is the decision, not an afterthought.
What breaks when this is ignored
- Narrow dies for a sharp-looking corner: they mark the face and multiply tonnage.
- Wide dies on a flange that cannot bridge the shoulders.
- Radius called on the drawing that the die can never produce, whatever punch goes in.
Notes from the floor
- Punch with 0.5 R or sharper and the part still takes the die radius. Radius below 1 × T needs coining.
All eight formulas on paper
The Press Brake Reference prints every table with the arithmetic worked, plus ten field notes. CA$29, PDF.
See the reference